■SHIGIYA Plus Products (Click to view details)
・Easy Outer Diameter Measurement/RAKSOK <NEW>
・2-point steady rest with variable shoe/FUREPITA <NEW>
・AI Thermal Displacement Compensation/DANKILESS
・Grinding Wheel Automatic Teaching Function/MAKASET
・5th generation interactive automatic programming system/S3Pro
Easy Outer Diameter Measurement
RAKSOK is the ideal outside diameter dimensioning equipment for high-mix low-volume production!
No setup and no zero-setting for each workpiece!
Dimension compensation, which is usually performed with a constant dimension amplifier, can be input using interactive software!
High-precision machining with full-stage constant dimensioning is possible even for single workpieces.

The RAKSOK lineup includes the large RAKSOK400(*1) and the small RAKSOK40(*2).

*1 Measuring range φ8 to 400mm
*2 Measuring range φ5 to 150mm with a maximum diameter difference of φ40 specified (e.g., φ10 to 50)
2-point steady rest with variable shoe
If a spline and a cylindrical part are ground simultaneously, the cylindrical part is affected by the spline shape, resulting in poor roundness.
That’s where FUREPITA comes in!
It can even be used with odd-numbered teeth, which are easily affected by the use of steady rests!
The angle of the shoe can be adjusted to minimize the effects of intermittent grinding of splines and improve roundness.

AI Thermal Displacement Compensation
Ability to compensate for machine displacement in real time, even when the temperature around the machine changes, using AI thermal displacement compensation.
Grinding dimensions are therefore stabilized without warm-up operation, and power consumption during non-grinding time is also reduced.
◎Warm-up operation is not required, so dimensions are stable in a short time even after a cold start or after an interval of grinding such as a lunch break.
Note) DANKILESS is not compensation by an actual measurement method such as an in-process O.D. gauge, so accuracy is not guaranteed.
Effects of Using DANKILESS
-01-scaled.jpg)
Grinding Wheel Automatic Teaching Function
◎Dress position repeatability : ±1 μm (air sensor)
.jpg)
5th generation interactive automatic programming system
◎ Multi-screen display allows data to be created while viewing registered screens.

◎ Registration of frequently used screens enables quick access to the desired screen.

◎ Support function for work procedures by setting up steps.

